Metrohm 900 Touch Control Manual - Manual (Page 487)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
29 Parameters
900 Touch Control
￭￭￭￭￭￭￭￭ 471
29.17.3 Controlling pumps (PUMP)
The PUMP command is used to control the pumps mounted on or con-
nected to the tower of the sample changer.
Tower
Selection of the tower, with which the command is carried out. Both
Tower 1 and Tower 2 can always be selected, even if your Sample Pro-
cessor has only one tower.
Selection 1 | 2
Default value 1
1
View from the front, the right tower.
2
View from the front, the left tower.
Pump
Selection of the pump.
Selection 1 | 2 | 1 + 2
Default value 1
1
Pump 1 of the selected tower is switched.
2
Pump 2 of the selected tower is switched.
1 + 2
Both pumps of the selected tower are switched at the same time.
Status/Duration
Switching the pump(s) on and off.
Input range 0 - 999 s (Increment: 1)
The pump is running during this time.
Selection on | off
Default value on
on
The pump is switched on. The pump is running until it is explicitly
switched off. If the determination is canceled with the key [
], the
pump is also switched off.
off
The pump is switched off.