Metrohm 900 Touch Control Manual - Manual (Page 366)

29.6 Bromine index determination (BRC)
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
350 ￭￭￭￭￭￭￭￭
900 Touch Control
29.6.6 Control device
The control device the determination is carried out with is selected under
[Control device]. Control devices are defined under System
▶ Device
manager.
NOTE
This button is only displayed when several control devices have been
configured.
Control device
Selection of the control device from the list of devices. Only those devices
are displayed which are able to carry out the command. The control devi-
ces do not have to be connected. This allows to transfer methods more
easily from one system to another.
Selection Selection of configured control devices
29.6.7 Sensor
The parameters for the sensor are edited under [Sensor].
Sensor
Selection of the sensor from the sensor list. The selection depends on the
measuring mode. Sensors are defined under System
▶ Sensors. You can
also enter a sensor name which is not contained in the sensor list. When a
determination is started there is a check whether the sensor is contained
in the sensor list.
Selection Selection of configured sensors
I(pol)
The polarization current is the current that is applied to a polarizable elec-
trode during voltametric measurement.
The values that are actually adjustable may vary from the values specified
here, depending on the hardware. The binding values can be found in the
"Technical specifications" chapter for the control device used.
Input range –125.0 - 125.0 µA (Increment: 2.5)
Selection –1.0 µA | 1.0 µA
Default value 1.0 µA