Metrohm 900 Touch Control Manual - Manual (Page 103)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
11 Device manager
900 Touch Control
￭￭￭￭￭￭￭￭ 87
Entry x.x.x.x
Default value empty
MAC address
Unambiguous address of the network adaptor for identification within a
network. This parameter cannot be edited.
NetBIOS name
Unambiguous designation of the device within the network. This parame-
ter cannot be edited.
11.4 Metrohm control devices
The following Metrohm devices can be used as control devices:
￭ Titrandos
￭ USB Sample Processors
￭ 846 Dosing Interface
￭ 867 pH Module
￭ 856 Conductivity Module
The following specifications apply for all of the control devices mentioned
above. Additional device configurations for the USB Sample Processor are
described in a separate chapter (see Chapter 11.5, page 91).
The dialog shows the control device with its measuring inputs, the MSB
connectors and connected peripheral devices (dosing device, stirrer,
Remote Box). If the control device is not connected, then the properties
dialog of the control device will be displayed directly (see Chapter 11.4.1,
page 88).
[Properties]
Open the properties dialog of the highlighted entry.