Metrohm 900 Touch Control Manual - Manual (Page 125)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
11 Device manager
900 Touch Control
￭￭￭￭￭￭￭￭ 109
Connector
Selection of the connection type for the printer.
Selection USB | Ethernet
Default value USB
USB
Local printer at a USB interface.
Ethernet
Network printer.
NOTE
The Touch Control prints the reports with a fixed resolution of 300
dpi. If you are using a printer with a resolution of 360 dpi (or a multiple
thereof, e.g. an Epson), then the text will be printed out somewhat
smaller than with printers with a resolution of 300 dpi (or a multiple
thereof, e.g. a Canon or HP).
11.7.1 PDF settings
Printer: Edit ▶ PDF settings
The settings for saving a report as a PDF file are defined in this dialog.
Memory
Memory location where the PDF file will be saved. The report will be saved
in the directory PDF_Report. This directory is created when a PDF file is
generated. The file name is appended with the date and time when the
determination was started and the date and time when the PDF was gen-
erated (e.g.: Identification 1-20130320-141044-20130320-141220).
The first date and time set indicates the start of the determination, the
second date and time set indicates the generation of the PDF file. This pre-
vents previously created PDF files from being overwritten each time a new
file is created, e.g. when a result is recalculated and the report is gener-
ated again.
All three memory locations are listed as possible selections, even if they
cannot be accessed at the moment.
Selection off | External memory 1 | External memory 2 |
Shared memory
Default value off
off
The report will not be saved as a PDF file.