Metrohm 900 Touch Control Manual - Manual (Page 444)

29.13 Calculations
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
428 ￭￭￭￭￭￭￭￭
900 Touch Control
Variable Description
MDC Drift for drift correction
DDC Time for drift correction
MCV End volume, i.e. total dosed volume at the end of the titration
MCQ End quantity, i.e. total amount of removed water or of generated bromine, respectively, at the end
of the titration (in µg)
MCC Final charge, i.e. total charge in mAs at the end of the titration
MCM End measured value
MCT End temperature
MMP Number of measuring points in measuring point list
MTS Stop type
Format = Text
LV Currently dosed volume of the ongoing determination
LM Current measured value of the ongoing determination
LD Current duration of the ongoing titration or measuring command
LT Current temperature of the ongoing determination
Sensor
MEN Electrode zero point pH(0) or E(0)
MSL Electrode slope
MVA Electrode variance (mathematically only defined for three standards or more); CAL Conc: calculated
only if calibration is carried out with a minimum of four standards
MCL Cell constant of conductivity measuring cell
Evaluations
FP# Volume of fixed endpoint FP# (# = 1…9)
FM# Measured value of fixed endpoint FP# (# = 1…9)
FT# Temperature at fixed endpoint FP# (# = 1…9)
FD# Time at fixed endpoint FP# (# = 1…9)
HP# Volume of pK value / half neutralization potential HP#
HM# Measured value of pK value / half neutralization potential HP#
HT# Temperature at pK value / half neutralization potential HP#
HD# Time at pK value / half neutralization potential HP#
XIP Volume/quantity of minimum measured value
XIM Minimum measured value
XIT Temperature at minimum measured value
XID Time at minimum measured value