Metrohm 900 Touch Control Manual - Manual (Page 429)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
29 Parameters
900 Touch Control
￭￭￭￭￭￭￭￭ 413
Measured value (measuring mode U, Ipol):
Input range
–2,000.0 - 2,000.0 mV
Default value –2,000.0 mV
Measured value (measuring mode Upol):
Input range
–200.00 - 200.00 µA
Default value –200.00 µA
Measured value (measuring mode T):
Input range
–20.0 - 150.0 °C
Default value –20.0 °C
Measured value (measuring mode Cond):
Input range
0.0001 - 999.9999 mS/cm
Default value 0.0001 mS/cm
Time:
Input range
0.0 - 999,999.9 s
Default value 0.0 s
Volume:
Input range
0.00000 - 9,999.99 mL
Default value 0.00000 mL
Upper limit
Measured value, time or volume for the upper limit.
The values that are actually measurable may vary from the values specified
here, depending on the hardware. The binding measurement value ranges
can be found in the "Technical specifications" chapter for the control
device used.
Measured value (measuring mode pH):
Input range
–20.000 - 20.000
Default value 20.000
Measured value (measuring mode U, Ipol):
Input range
–2,000.0 - 2,000.0 mV
Default value 2,000.0 mV
Measured value (measuring mode Upol):
Input range
–200.00 - 200.00 µA
Default value 200.00 µA