Metrohm 900 Touch Control Manual - Manual (Page 302)

29.1 Dynamic equivalence point titrations (DET)
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
286 ￭￭￭￭￭￭￭￭
900 Touch Control
NOTE
When you define a result variable instead of a numerical value as limit
value (see Chapter 32.5, page 491), then just one window can be
defined.
[New]
Define a new window. This is only possible when not the entire range is
covered yet.
[Delete]
Delete the selected window.
[Edit]
Edit the settings of the selected window.
Lower limit
Measured value or volume for the lower limit.
The values that are actually measurable may vary from the values specified
here, depending on the hardware. The binding measurement value ranges
can be found in the "Technical specifications" chapter for the control
device used.
Measured value (measuring mode pH):
Input range
–20.000 - 20.000
Default value –20.000
Measured value (measuring mode U, Ipol):
Input range
–2,000.0 - 2,000.0 mV
Default value –2,000.0 mV
Measured value (measuring mode Upol):
Input range
–200.00 - 200.00 µA
Default value –200.00 µA
Volume:
Input range
0.00000 - 9,999.99 mL
Default value 0.00000 mL
Upper limit
Measured value or volume for the upper limit.
The values that are actually measurable may vary from the values specified
here, depending on the hardware. The binding measurement value ranges