Metrohm 900 Touch Control Manual - Manual (Page 515)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
32 Appendix
900 Touch Control
￭￭￭￭￭￭￭￭ 499
Proceed as follows:
1 Double-click on the file SetupAuditTrailViewer 1.1.exe.
The dialog Welcome to the AuditTrailViewer Setup Wizard is
displayed.
2 Click on [Next >].
The dialog License Agreement is displayed.
3 Click on [I Agree] to accept the contractual conditions.
The dialog Choose Install Location is displayed. A memory loca-
tion for the AuditTrailViewer is suggested in this dialog.
4 If you accept the suggested memory location, click on [Next >].
or
Select a different memory location and click on [Next >].
The dialog Confirm Installation is displayed.
5 Click on [Install] to install the AuditTrailViewer.
As soon as the installation is completed, the dialog Installation
Complete is displayed.
6 Click on [Next >].
The dialog Completing the AuditTrailViewer Setup Wizard is
displayed.
7 If the AuditTrailViewer should not be started immediately, deactivate
the check box Run AuditTrailViewer.
8 Click on [Finish].
If the preceding instruction step has been skipped, then the
AuditTrailViewer will start.
32.8.2 Opening the Audit Trail
Create a backup of the data and of the settings of your Touch Control
(see Chapter 12.3, page 125).
1 Open the backup on your PC.