Metrohm 900 Touch Control Manual - Manual (Page 286)

28.7 USB Sample Processor
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
270 ￭￭￭￭￭￭￭￭
900 Touch Control
￭ External positions (only with robotic arm and mounted Swing Head,
see Chapter 28.7.3, page 272)
For each of the four possible external positions, a specific working
position can be defined. Shift and rinse positions can only be defined
for all four external positions together. A special position is not possi-
ble.
Proceed as follows to assign the current lift position to a specific lift posi-
tion:
1 Move to lift position
￭ Enter the desired lift position in mm and tap on [Start].
The lift moves to the desired lift position.
2 Assign the lift position
￭ Tap on [Assign lift pos.].
The dialog Lift / Assign lift position is displayed.
￭ Select the desired specific lift position and tap on [Assign].
The current lift position is assigned to the specific lift position.
28.7.2 Moving to a rack position
Manual control: Sample Processor ▶ Rack position