Metrohm 900 Touch Control Manual - Manual (Page 191)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
16 Methods
900 Touch Control
￭￭￭￭￭￭￭￭ 175
￭ Define limits for the sample size
If you define limits, these will be monitored at the start and at the end
of the determination.
Below you will find an example demonstrating the effects on the main
dialog of the settings in this dialog (see "Modifying sample data", page
176).
Identification 1, Identification 2
on | off (Default value: on)
If this option is activated, then the input field for the sample identification
in the main dialog will be displayed.
Designation
A designation of your own choosing can be defined for the input field for
each method.
Entry 16 characters maximum
Fixed sample size
on | off (Default value: off)
Activate this parameter if the same sample amount is always to be used
for all determinations. If this is case, then you can define the sample size
here. It will be displayed in the main dialog, but it can no longer be
changed there.
Sample size
This parameter can only be edited when Fixed sample size is activated.
Input range –999999999 - 9999999999
Default value 1.0
Unit of sample size.
Selection g | mg | µg | mL | µL | pieces
Default value g