Metrohm 900 Touch Control Manual - Manual (Page 395)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
29 Parameters
900 Touch Control
￭￭￭￭￭￭￭￭ 379
Measuring mode pH:
Input range
–20.000 - 20.000
Selection off
Default value off
Measuring mode U, Ipol:
Input range
–2,000.0 - 2,000.0 mV
Selection off
Default value off
Measuring mode Upol:
Input range
–200.00 - 200.00 µA
Selection off
Default value off
Measuring mode T:
Input range
–20.0 - 150.0 °C
Selection off
Default value off
Measuring mode Conc:
Input range
0.001 - 999,999.999
The unit corresponds to the one of the standards
with which the calibration of the sensor has been
carried out.
Selection off
Default value off
Measuring mode Cond:
Input range
0.0001 - 999.9999 mS/cm
Selection off
Default value off
Temperature
This parameter is not available with the commands MEAS T (temperature
measurement) and MEAS Cond (conductivity measurement).
Temperature entered manually. The temperature is being continuously
measured when a temperature sensor is connected and when Temp.
measurement = automatic or continuous is defined (see sensor dialog
of the command). This value is used for temperature correction in pH and
concentration measurements.
Input range –20.0 - 150.0 °C
Default value 25.0 °C