Metrohm 900 Touch Control Manual - Manual (Page 82)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
66 ￭￭￭￭￭￭￭￭
900 Touch Control
10 Sensors
Main dialog: System ▶ Sensors
This chapter describes how you can create a list of the sensors used in the
system.
Five standard sensors are defined in the sensor list: pH electrode, Metal
electrode, Fluoride electrode, Temperature sensor and Conductiv-
ity sensor. These sensors cannot be deleted or renamed. A maximum of
25 additional sensors can be added to these sensors.
For each sensor, the following data is displayed in the sensor list:
￭ Designation
￭ Type
– pH: pH electrode
– Metal: Metal electrode
– ISE: Ion-selective electrode
– Temp.: Temperature sensor
– Cond.: Conductivity measuring cell
￭ Measuring input/control device (only for intelligent sensors if they are
connected)
Intelligent sensors are also indicated by IS and are depicted in green let-
tering.
The following sensor data is stored in the list of sensors:
￭ Name
Each sensor in the system is identified by its unambiguous name.
￭ Calibration data (for pH electrodes, ISE electrodes and conductivity
measuring cells only)