Metrohm 900 Touch Control Manual - Manual (Page 102)

11.3 Touch Control
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
86 ￭￭￭￭￭￭￭￭
900 Touch Control
Entry max. 32 characters
Default value empty
[Connect]
Establish the network connection. If the connection has been set up cor-
rectly, then all of the input fields will become inactive and the label
switches to [Disconnect]. The network connection can be disconnected
with this.
11.3.4 TCP/IP settings
900 Touch Control: Edit ▶ TCP/IP settings
If you have your Touch Control connected to your network, then you have
to define the network-relevant settings in this dialog. The Touch Control
requires an IP address so that it is identifiable on the network. The Touch
Control can acquire the IP address either dynamically from a DHCP server
or you can enter the address directly.
Get IP address automatically (DHCP)
on | off (Default value: on)
If this parameter is activated, then the Touch Control will obtain its IP
address directly from a DHCP server. In this case, the remaining parame-
ters can no longer be edited.
IP address
IP address for the Touch Control. IP addresses are 32-bit numbers and are
written as sequences of four decimals, each separated by a period, e.g.
"10.157.212.8".
Entry x.x.x.x
Default value empty
"x" is a decimal between 0 and 255.
Subnet mask
The net mask or subnet mask, together with the IP address, indicates to
which network the device to be connected belongs. Subnet masks are 32-
bit numbers and are written as sequences of four decimals, each separa-
ted by a period.
Entry x.x.x.x
Default value 255.255.255.0
Default gateway
IP address for the standard gateway. A gateway sets up connections to
several networks. It is located in the same subnet as the device to be con-
figured.