Metrohm 900 Touch Control Manual - Manual (Page 31)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Operation
900 Touch Control
￭￭￭￭￭￭￭￭ 15
6 Operation
6.1 Switching the instrument on and off
Switching on the instrument
CAUTION
Peripheral devices (e.g. printers) must be switched on before you switch
on the 900 Touch Control.
Proceed as follows:
1 ￭ Press the mains switch on the left-hand side of the rear panel of
the 900 Touch Control.
The 900 Touch Control and the control device are initialized and a
system test is carried out. This process takes some time.
￭ If a buret unit is attached, then a request appears to carry out the
Prepare function:
All tubings and the cylinder are rinsed with the Prepare function.
The preparing of the buret unit is described in chapter 28.3.3,
page 260.
￭ Confirm the message with [OK].
The main dialog is displayed: