Metrohm 900 Touch Control Manual - Manual (Page 106)

11.4 Metrohm control devices
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
90 ￭￭￭￭￭￭￭￭
900 Touch Control
Input range 1000 - 9999 K
Default value 4100 K
The default value applies to Metrohm sensors with
an NTC sensor. If no B value is given for your sensor
then you can retain the default value.
11.4.3 Properties – MSB connector
List of devices: Control device ▶ Edit ▶ MSB connector 1…4 ▶ Prop-
erties
In this dialog, you can define when the request to carry out the Prepare
function for connected dosing devices is to be displayed. This setting
applies for all dosing devices of the selected MSB connector. The manual
control contains a description of how to prepare the exchange unit and/or
the dosing unit (see Chapter 28.3.3, page 260).
Switch on
on | off (Default value: on)
If this parameter is activated, then you will be requested to prepare the
dosing device when the Touch Control is switched on.
Attach an exchange or dosing unit
on | off (Default value: on)
If this parameter is activated, then you will be requested to prepare the
dosing device when the exchange/dosing unit is attached.
Time interval
on | off (Default value: off)
Activate this parameter if you wish to receive a regular request to prepare
the dosing unit.