Metrohm 900 Touch Control Manual - Manual (Page 49)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 System settings
900 Touch Control
￭￭￭￭￭￭￭￭ 33
7.3.2 Creating an identification profile
User list: User ▶ Create ID profile
If you plan to carry out the login with an identification profile (see Chapter
7.3.3, page 33), then you must first create an identification profile on a
storage medium for each user. A check can then be made at the time of
login as to whether or not the user does exist and whether or not he or
she is working in the expert dialog or in the routine dialog. After a suc-
cessful login the routine dialog settings stored on the card are loaded.
NOTE
In addition to the user name, the current routine dialog settings are
also stored in this identification profile. This means you can define user-
specific routine dialog settings for each user. However, you must con-
figure them (see "Configuring the routine dialog", page 26), before
you create the identification profile.
Before you create the identification profile, check whether the desired
routine dialog settings are active.
1 Plug in a storage medium
Plug in the USB storage medium.
2 Select a user
In the user list, select the user for whom the profile is to be created.
3 Create the identification profile
Tap on [Create ID profile].
The user configuration and the current routine dialog settings are
saved.
7.3.3 Defining login options
Main dialog: System ▶ System settings ▶ User admin. ▶ Login
options
There are a number of different ways to log onto the system:
￭ Without login
￭ Login via user name
￭ Login via user name and password
￭ Login via identification profile
￭ Login via identification profile and password