Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 304)

set cos state
9-18 Policy Classification Configuration
Commands
set cos state
Use this command to enable or disable Class of Service.
Syntax
set cos state {enable | disable}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
For information about... Refer to page...
set cos state 9-18
show cos state 9-19
clear cos state 9-19
set cos settings 9-20
clear cos settings 9-21
show cos settings 9-21
set cos port-config 9-22
show cos port-config 9-23
clear cos port-config 9-24
set cos port-resource 9-25
show cos port-resource 9-26
clear cos port-resource 9-26
set cos reference 9-27
show cos reference 9-28
clear cos reference 9-29
show cos unit 9-30
clear cos all-entries 9-30
show cos port-type 9-31
enable | disable Enables or disables Class of Service on the switch. Default state is
disabled.