Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 117)

set port jumbo
D-Series CLI Reference 4-13
Example
This example shows how to display the status of jumbo frame support for ge .1.1:
D2(su)->show port jumbo ge.1.1
Port Number Jumbo Status Max Frame Size
------------- --------------- ------------------
ge.1.1 Enable
9216
set port jumbo
Use this command to enable or disable jumbo frame support on one or more ports.
Syntax
set port jumbo {enable | disable}[port-string]
Parameters
Defaults
If port‐string is not specified, jumbo frame support will be enabled or disabled on all ports.
Mode
Switch command, read‐write.
Example
This example shows how to enable jumbo frame support for Gigabit Ethernet port 14 in slot 3:
D2(su)->set port jumbo enable ge.3.14
clear port jumbo
Use this command to reset jumbo frame support status to enabled on one or more ports.
Syntax
clear port jumbo [port-string]
Parameters
Defaults
If port‐string is not specified, jumbo frame support status will be reset on all ports.
enable | disable Enables or disables jumbo frame support.
port‐string (Optional) Specifies the port(s) on which to disable or enable jumbo
frame support. For a detailed description of possible port‐string values,
refer to “
Port String Syntax Used in the CLI ” on page 4‐1.
port‐string (Optional) Specifies the port(s) on which to reset jumbo frame
support status to enabled. For a detailed description of possible
port‐string values, refer to “
Port String Syntax Used in the CLI ” on
page 4‐1.