Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 330)

Configuring IGMP at Layer 2
11-2 IGMP Configuration
multicast switch/router it passes through to ensure that traffic is only passed to the hosts that
subscribed to this service.
Configuring IGMP at Layer 2
Purpose
To configure IGMP snooping from the switch CLI.
Commands
show igmpsnooping
Use this command to display IGMP snooping information.
Syntax
show igmpsnooping
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
For information about... Refer to page...
show igmpsnooping 11-2
set igmpsnooping adminmode 11-3
set igmpsnooping interfacemode 11-4
set igmpsnooping groupmembershipinterval 11-4
set igmpsnooping maxresponse 11-5
set igmpsnooping mcrtrexpiretime 11-5
set igmpsnooping add-static 11-6
set igmpsnooping remove-static 11-7
show igmpsnooping static 11-7
show igmpsnooping mfdb 11-8
clear igmpsnooping 11-8