Show spantree mstilist, Set spantree msti, Show spantree mstilist -12 set spantree msti -12 – Enterasys Networks Enterasys D2 D2G124-12P User Manual
Page 204
show spantree mstilist
6-12 Spanning Tree Configuration
show spantree mstilist
Use this command to display a list of Multiple Spanning Tree (MST) instances configured on the
device.
Syntax
show spantree mstilist
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display a list of MST instances. In this case, SID 2 has been configured:
D2(su)->show spantree mstilist
Configured Multiple Spanning Tree instances:
2
set spantree msti
Use this command to create or delete a Multiple Spanning Tree instance.
Syntax
set spantree msti sid sid {create | delete}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to create an MST instance 2:
D2(su)->set spantree msti sid 2 create
sid sid
Sets the Multiple Spanning Tree ID. Valid values are 1 ‐ 4094.
D‐Series devices will support up to 4 MST instances.
create | delete
Creates or deletes an MST instance.