Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 75)

set boot system
D-Series CLI Reference 2-37
Example
This example shows how to display the switch’s boot firmware image:
D2(su)->show boot system
Current system image to boot: bootfile
set boot system
Use this command to set the firmware image the switch loads at startup.
Syntax
set boot system filename
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the boot firmware image file to “newimage”:
D2(su)->set boot system newimage
Starting and Configuring Telnet
Purpose
To enable or disable Telnet, and to start a Telnet session to a remote host. The D‐Series switch
allows a total of four inbound and / or outbound Telnet session to run simultaneously.
Commands
The commands used to enable, start and configure Telnet are listed below.
filename Specifies the name of the firmware image file.
For information about... Refer to page...
show telnet 2-38
set telnet 2-38
telnet 2-39