Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 379)

clear rmon history
D-Series CLI Reference 13-7
Defaults
If buckets is not specified, the maximum number of entries maintained will be 50.
If not specified, interval will be set to 30 seconds.
If owner is not specified, monitor will be applied.
Mode
Switch command, read‐write.
Example
This example shows how configure RMON history entry 1 on port ge .2.1 to sample every 20
seconds:
D2(rw)->set rmon history 1 ge.2.1 interval 20
clear rmon history
Use this command to delete one or more RMON history entries or reset one or more entries to
default values. For specific values, refer to “
set rmon history ” on page 13‐6.
Syntax
clear rmon history {index-list | to-defaults}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to delete RMON history entry 1:
D2(rw)->clear rmon history 1
Alarm Group Commands
Purpose
To display, configure, and clear RMON alarm entries and properties.
index‐list Specifies one or more history entries to be deleted, causing them to
disappear from any future RMON queries.
to‐defaults Resets all history entries to default values. This will cause entries to
reappear in RMON queries.