Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 231)

set spantree lp
D-Series CLI Reference 6-39
Commands
set spantree lp
Use this command to enable or disable the Loop Protect feature per port and optionally, per SID.
The Loop Protect feature is disabled by default. See “Loop Protect” on page 2. for more
information.
Syntax
set spantree lp port-string {enable | disable} [sid sid]
Parameters
For information about... Refer to page...
set spantree lp 6-39
show spantree lp 6-40
clear spantree lp 6-41
show spantree lplock 6-41
clear spantree lplock 6-42
set spantree lpcapablepartner 6-42
show spantree lpcapablepartner 6-43
clear spantree lpcapablepartner 6-44
set spantree lpthreshold 6-44
show spantree lpthreshold 6-45
clear spantree lpthreshold 6-45
set spantree lpwindow 6-46
show spantree lpwindow 6-46
clear spantree lpwindow 6-47
set spantree lptrapenable 6-47
show spantree lptrapenable 6-48
clear spantree lptrapenable 6-48
set spantree disputedbpduthreshold 6-48
show spantree disputedbpduthreshold 6-49
clear spantree disputedbpduthreshold 6-50
show spantree nonforwardingreason 6-50
port‐string Specifies port(s) on which to enable or disable the Loop Protect feature.
enable | disable Enables or disables the feature on the specified port.
sid sid (Optional) Enables or disables the feature for specific Spanning Tree(s).
Valid values are 0 ‐ 4094. If not specified, SID 0 is assumed.