Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 61)

set system name
D-Series CLI Reference 2-23
set system name
Use this command to configure a name for the system.
Syntax
set system name [string]
Parameters
Defaults
If string is not specified, the system name will be cleared.
Mode
Switch command, read‐write.
Example
This example shows how to set the system name to Information Systems:
D2(su)->set system name “Information Systems”
set system location
Use this command to identify the location of the system.
Syntax
set system location [string]
Parameters
Defaults
If string is not specified, the location name will be cleared.
Mode
Switch command, read‐write.
Example
This example shows how to set the system location string:
D2(su)->set system location “Bldg N32-04 Closet 9”
string (Optional) Specifies a text string that identifies the system.
Note: A name string containing a space in the text must be enclosed in
quotes as shown in the example below.
string (Optional) Specifies a text string that indicates where the system is
located.
Note: A location string containing a space in the text must be
enclosed in quotes as shown in the example below.