Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 463)

show multiauth session-timeout
D-Series CLI Reference 15-39
Parameters
Defaults
If no authentication method is specified, the idle timeout value is reset to its default value of 0 for
all authentication methods.
Mode
Switch mode, read‐write.
Example
This example resets the idle timeout value for all authentication methods to 0 seconds.
D2(su)->clear multiauth idle-timeout
show multiauth session-timeout
Use this command to display the session timeout value, in seconds, for all authentication methods.
Syntax
show multiauth session-timeout
Parameters
None.
Defaults
None.
Mode
Switch mode, read‐only.
Example
This example displays the session timeout values for all authentication methods.
D2(su)->show multiauth session-timeout
Authentication type Timeout (sec)
------------------- -------------
dot1x 0
pwa 0
mac 0
dot1x (Optional) Specifies the IEEE 802.1X port‐based network access control
authentication method for which to reset the timeout value to its
default.
mac (Optional) Specifies the Enterasys MAC authentication method for
which to reset the timeout value to its default.
pwa (Optional) Specifies the Enterasys Port Web Authentication method for
which to reset the timeout value to its default.