Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 277)

Configuring Diffserv Policies and Assigning Classes
D-Series CLI Reference 8-9
Configuring Diffserv Policies and Assigning Classes
Purpose
To review, create, and configure Diffserv policies and assign classes.
Commands
The commands used to review, create, and configure Diffserv policies and assign classes are listed
below and described in the associated section as shown.
show diffserv policy
Use this command to display information about Diffserv policies.
Syntax
show diffserv policy {summary | detailed policyname}
Parameters
Defaults
None.
Mode
Switch command. Read‐Only.
For information about... Refer to page...
show diffserv policy 8-9
set diffserv policy create 8-10
set diffserv policy delete 8-10
set diffserv policy class 8-11
set diffserv policy mark 8-11
set diffserv policy police style simple 8-12
set diffserv policy police action conform 8-13
set diffserv policy police action nonconform 8-13
set diffserv policy rename 8-14
summary Displays Diffserv policy summary information.
detailed
policyname Displays detailed Diffserv information for a specific policy.