Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 419)

clear dhcp pool netbios-name-server
D-Series CLI Reference 14-25
Syntax
set dhcp pool poolname netbios-name-server address [address2 ... address8]
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example assigns a NetBIOS name server at 10.15.10.1 to the address pool being configured.
D2(rw)->set dhcp pool auto1 netbios-name-server 10.15.10.1
clear dhcp pool netbios-name-server
Use this command to remove the NetBIOS namer server list from the address pool being
configured.
clear dhcp pool poolname netbios-name-server
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example removes the NetBIOS name server list from the address pool auto1.
D2(rw)->clear dhcp pool auto1 netbios-name-server
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.
address Specifies the IP address of a NetBIOS name server.
address2 ... address8 (Optional) Specifies, in order of preference, up to 7 additional NetBIOS
name server addresses.
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.