Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 251)

show port vlan
D-Series CLI Reference 7-7
Commands
show port vlan
Use this command to display port VLAN identifier (PVID) information. PVID determines the
VLAN to which all untagged frames received on one or more ports will be classified.
Syntax
show port vlan [port-string]
Parameters
Defaults
If port ‐string is not specified, port VLAN information for all ports will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display PVIDs assigned to ge.2.1 through 6. In this case, untagged
frames received on these ports will be classified to VLAN 1:
D2(su)->show port vlan ge.2.1-6
ge.2.1 is set to 1
ge.2.2 is set to 1
ge.2.3 is set to 1
ge.2.4 is set to 1
ge.2.5 is set to 1
ge.2.6 is set to 1
For information about... Refer to page...
show port vlan 7-7
set port vlan 7-8
clear port vlan 7-8
show port ingress filter 7-9
set port ingress filter 7-10
show port discard 7-10
set port discard 7-11
port‐string (Optional) Displays PVID information for specific port(s). For a detailed
description of possible port‐string values, refer to “
Port String Syntax Used
in the CLI ” on page 4‐1.