Globally enabling or disabling diffserv, Purpose, Command – Enterasys Networks Enterasys D2 D2G124-12P User Manual
Page 270: Set diffserv adminmode, Globally enabling or disabling diffserv -2, Purpose -2 command -2, Set diffserv adminmode -2
Globally Enabling or Disabling Diffserv
8-2 Differentiated Services Configuration
Globally Enabling or Disabling Diffserv
Purpose
To globally enable or disable Diffserv on the device.
Command
The command used to globally enable or disable Diffserv on the device is listed below and
described in the associated section as shown.
set diffserv adminmode
Use this command to globally enable or disable Diffserv on the device. By default, this function is
disabled at device startup.
Syntax
set diffserv adminmode {enable | disable}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to enable Diffserv:
D2(rw)->set diffserv adminmode enable
For information about...
Refer to page...
set diffserv adminmode
enable | disable
Enables or disables Diffserv.