Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 234)

clear spantree lplock
6-42 Spanning Tree Configuration
Mode
Switch command, read‐only.
Example
This example shows how to display Loop Protect lock status on ge .1.1:
D2(rw)->show spantree lplock port ge.1.1
The LoopProtect lock status for port ge.1.1
, SID 0 is UNLOCKED
clear spantree lplock
Use this command to manually unlock a blocked port and optionally, per SID. The default state is
unlocked.
Syntax
clear spantree lplock port-string [sid sid]
Parameters
Defaults
If no SID is specified, SID 0 is assumed.
Mode
Switch command, read‐only.
Example
This example shows how to clear Loop Protect lock from ge .1.1:
D2(rw)->show spantree lplock port ge.1.1
The LoopProtect lock status for port ge.1.1
, SID 0 is LOCKED
D2(rw)->clear spantree lplock ge.1.1
D2(rw)->show spantree lplock port ge.1.1
The LoopProtect lock status for port ge.1.1
, SID 0 is UNLOCKED
set spantree lpcapablepartner
Use this command to specify per port whether the link partner is Loop Protect capable. See “Loop
Protect” on page 2. for more information.
Syntax
set spantree lpcapablepartner port-string {true | false}
Parameters
port‐string Specifies port(s) for which to clear the Loop Protect lock.
sid sid (Optional) Specifies the specific Spanning Tree(s) for which to clear the
Loop Protect lock. Valid values are 0 ‐ 4094. If not specified, SID 0 is
assumed.
port‐string Specifies port(s) for which to configure a Loop Protect capable link
partner.