Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 456)

clear multiauth mode
15-32 Security Configuration
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Usage
Multiauth multi mode requires that MAC, PWA, and 802.1X authentication be enabled globally,
and configured appropriately on the desired ports according to their corresponding command
sets described in this chapter. Refer to “
Configuring 802.1X Authentication ” on page 15‐9 and
“ Configuring MAC Authentication ” on page 15‐19 and“ Configuring Port Web Authentication
(PWA) ” on page 15‐57.
Example
This example shows how to enable simultaneous multiple authentications:
D2(rw)->set multiauth mode multi
clear multiauth mode
Use this command to clear the system authentication mode.
Syntax
clear multiauth mode
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear the system authentication mode:
D2(rw)->clear multiauth mode
multi Allows the system to use multiple authenticators simultaneously (802.1x,
PWA, and MAC Authentication) on a port. This is the default mode.
strict User must authenticate using 802.1x authentication before normal traffic
(anything other than authentication traffic) can be forwarded.