Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 253)

show port ingress filter
D-Series CLI Reference 7-9
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset ports ge .1.3 through 11 to a VLAN ID of 1 (Host VLAN):
D2(su)->clear port vlan ge.1.3-11
show port ingress filter
Use this command to show all ports that are enabled for port ingress filtering, which limits
incoming VLAN ID frames according to a port VLAN egress list. If the VLAN ID specified in the
received frame is not on the port’s VLAN egress list, then that frame is dropped and not
forwarded.
Syntax
show port ingress-filter [port-string]
Parameters
Defaults
If port‐string is not specified, ingress filtering status for all ports will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display the port ingress filter status for ports 10 through 15 in slot 1.
In this case, the ports are disabled for ingress filtering:
D2(su)->show port ingress-filter ge.1.10-15
Port State
-------- ---------
ge.1.10 disabled
ge.1.11 disabled
ge.1.12 disabled
ge.1.13 disabled
ge.1.14 disabled
ge.1.15 disabled
port‐string (Optional) Specifies the port(s) for which to display ingress filtering status.
For a detailed description of possible port‐string values, refer to “
Port String
Syntax Used in the CLI ” on page 4‐1.