Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 413)

clear dhcp pool bootfile
D-Series CLI Reference 14-19
Mode
Switch command, read‐write.
Example
This example sets the boot image filename for address pool named “auto1.”
D2(rw)->set dhcp pool auto1 bootfile image1.img
clear dhcp pool bootfile
Use this command to remove a default boot image from the address pool being configured.
Syntax
clear dhcp pool poolname bootfile
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example removes the boot image filename from address pool named “auto1.”
D2(rw)->clear dhcp pool auto1 bootfile
set dhcp pool next-server
Use this command to specify the file server from which the default boot image is to be loaded by
the client.
Syntax
set dhcp pool poolname next-server ip-address
Parameters
Defaults
None.
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.
ip‐address Specifies the IP address of the file server the DHCP client should contact
to load the default boot image.