Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 313)

set cos reference
D-Series CLI Reference 9-27
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example clears the data rate to 0 for IRL resource index 1 for group 2.0.
D2(su)->clear cos port-resource irl 2.0 1 rate
set cos reference
Use this command to set the Class of Service inbound rate limiting reference configuration.
Syntax
set cos reference irl group-type-index reference rate-limit irl-index
Parameters
Defaults
None.
irl Specifies that an IRL resource is to be cleared.
all Clear all IRL resources for all port groups.
group‐type‐index Specifies an inbound rate limiting port group/type index. Valid entries are
in the form of group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
irl‐index (Optional) Inbound rate limiter resource index associated with the
specified port group. Valid values range from 0 to 99.
unit Clear the unit of measure for the inbound rate limiter.
rate Clear the data rate for this inbound rate limiter.
type Clear the action for the rate limiter.
irl Specifies that an IRL reference is being configured.
group‐type‐index Specifies an inbound rate limiting port group/type index. Valid entries are
in the form of group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
reference IRL reference number associated with this entry.
rate‐limit irl‐index Rate limiter (IRL resource index) to bind this reference to. Valid values
range from 0 to 99.