Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 323)

set port priority-queue
D-Series CLI Reference 10-5
Parameters
Defaults
If port-string is not specified, priority queue information for all ports will be
displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display priority queue information for ge .1.1. In this case, frames with
a priority of 0 are associated with transmit queue 1; frames with 1 or 2 priority, are associated with
transmit queue 0; and so forth:
D2(su)->show port priority-queue ge.1.1
Port P0 P1 P2 P3 P4 P5 P6 P7
--------- -- -- -- -- -- -- -- --
ge.1.1 1 0 0 2 3 4 5 5
set port priority-queue
Use this command to map 802.1D (802.1p) priorities to transmit queues. This enables you to
change the transmit queue (0 to 7, with 0 being the lowest priority queue) for each port priority of
the selected port. You can apply the new settings to one or more ports.
Syntax
set port priority-queue port-string priority queue
Parameters
Defaults
None.
Mode
Switch command, read‐write.
port‐string (Optional) Displays the mapping of priorities to transmit queues for one
or more ports.
port‐string Specifies the port(s) for which to set priority‐to‐queue mappings. For a
detailed description of possible port‐string values, refer to “
Port String
Syntax Used in the CLI ” on page 4‐1.
priority Specifies a value of 0 through 7 (0 is the lowest level) that determines
what priority frames will be transmitted on the transmit queue entered in
this command.
queue Specifies a value of 0 through 5 (0 is the lowest level) that determines the
queue on which to transmit the frames with the port priority entered in
this command.