Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 106)

Port Configuration Summary
4-2 Port Configuration
Port Slot/Unit Parameters Used in the CLI
The “unit” parameter is often used interchangeably with “module” in the standalone switch CLI
to indicate a module slot location.
Examples
This example shows the port‐string syntax for specifying the 1‐Gigabit Ethernet port 14 in slot 3 .
ge.3.14
This example shows the port‐string syntax for specifying all 1‐Gigabit Ethernet ports in slot 3 in the
system.
ge.3.*
This example shows the port‐string syntax for specifying all ports (of any interface type) in the
system.
*.*.*
Configuring SFP Ports for 100BASE-FX
By default, SFP ports in the D2G124‐12 and D2G124‐12P support 1‐Gigabit tranceivers (Mini‐
GBICs) for 1000BASE‐LX/SX fiber‐optic connections and 1000BASE‐T copper connections.
Optionally, these ports can support a Fast Ethernet tranceiver for 100BASE‐FX connections when
that tranceiver is installed and
Procedure 4‐1 is completed on each applicable port:
Note: You can use a wildcard (*) to indicate all of an item. For example, ge.3.* would represent all
1-Gigabit Ethernet (ge) ports in slot 3.
Procedure 4-1 Configuring SFP Ports for 100BASE-FX
Step Task Command(s)
1.
Disable the port’s auto-negotiation.
set port negotiation port-string
disable
2. Set the port’s advertised ability to 100BASE-TX
full duplex mode. set port advertise port-string
100txfd
3. Set the port speed to 100 Mbps. set port speed port-string 100
4. Set the port duplex mode to full. set port duplex port-string full
5. (Optional) Verify the new settings. show port status port-string