Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 219)

clear spantree spanguardtimeout
D-Series CLI Reference 6-27
Syntax
set spantree spanguardtimeout timeout
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the SpanGuard timeout to 600 seconds:
D2(su)->set spantree spanguardtimeout 600
clear spantree spanguardtimeout
Use this command to reset the Spanning Tree SpanGuard timeout to the default value of 300
seconds.
Syntax
clear spantree spanguardtimeout
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the SpanGuard timeout to 300 seconds:
D2(rw)->clear spantree spanguardtimeout
show spantree spanguardlock
Use this command to display the SpanGuard lock status of one or more ports.
Syntax
show spantree spanguardlock [port-string]
timeout Specifies a timeout value in seconds. Valid values are 0 to 65535.
A value of 0 will keep the port locked until manually unlocked. The default
value is 300 seconds.