Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 104)

clear ciscodp
3-12 Discovery Protocol Configuration
Examples
This example shows how to set the Cisco DP port voice VLAN ID to 3 on port ge .1.6 and enable
the port operational state.
D2(rw)->set ciscodp port status enable vvid 3 ge.1.6
This example shows how to set the Cisco DP extended trust mode to untrusted on port ge .1.5 and
set the CoS priority to 1.
D2(rw)->set ciscodp port trusted no cos 1 ge.1.5
clear ciscodp
Use this command to clear the Cisco discovery protocol back to the default values.
Syntax
clear ciscodp [status | timer | holdtime | {port {status | vvid | trust | cos}
[port-string]}]
Parameters
Defaults
If no parameters are entered, all Cisco DP parameters are reset to the defaults globally and for all
ports.
Mode
Switch mode, read‐write.
Examples
This example shows how to clear all the Cisco DP parameters back to the default settings.
D2(rw)->clear ciscodp
This example shows how to clear the Cisco DP status on port ge .1.5.
D2(rw)->clear ciscodp port status ge.1.5
Note: The Cisco Discovery Protocol must be globally enabled using the set ciscodp status
command before operational status can be set on individual ports.
status Clears global CiscoDP enable status to default of auto.
timer Clears the time between CiscoDP PDU transmissions to default of 60
seconds.
holdtime Clears the time‐to‐live for CiscoDP PDU data to default of 180 seconds.
port Clears the CiscoDP port configuration.
status Clears the individual port operational status to the default of enabled.
vvid Clears the individual port voice VLAN for CiscoDP PDU transmission
to 0.
trust Clears the trust mode configuration of the port to trusted.
cos Clears the CoS priority for untrusted traffic of the port to 0.
port‐string (Optional) Specifies the port(s) on which status will be set.