Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 299)

clear policy all-rules
D-Series CLI Reference 9-13
Defaults
When applicable, data and mask must be specified for individual rules to be cleared.
Mode
Switch command, read‐write.
Examples
This example shows how to delete Ethernet II Type 1526 classification rule entries associated with
policy profile 1 from all ports
D2(su)->clear policy rule 1 ether 1526
This example shows how to remove a rule from policy profile 5 that will forward UDP frames
from source port 45:
D2(su)->clear policy rule 5 udpportsource 45 forward
clear policy all-rules
Use this command to remove all policy classification rules.
Syntax
clear policy all-rules
Parameters
None.
Defaults
None.
profile‐index Specifies a policy profile for which to delete classification rules. Valid
profile‐index values are 1 ‐ 255.
all‐pid‐entries Deletes all entries associated with the specified policy profile.
ether Deletes associated Ethernet II classification rule.
icmptype Deletes associated ICMP classification rule.
ipproto Deletes associated IP protocol classification rule.
ipdestsocket Deletes associated IP destination classification rule.
ipsourcesocket Deletes associated IP source classification rule.
iptos Deletes associated IP Type of Service classification rule.
macdest Deletes associated MAC destination address classification rule.
macsource Deletes associated MAC source address classification rule.
tcpdestport Deletes associated TCP destination port classification rule.
tcpsourceport Deletes associated TCP source port classification rule.
udpdestport Deletes associated UDP destination port classification rule.
udpsourceport Deletes associated UDP source port classification rule.