Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 430)

clear radius
15-6 Security Configuration
Examples
This example shows how to enable the RADIUS client for authenticating with RADIUS server 1 at
IP address 192.168.6.203, UDP authentication port 1812, and an authentication password of
“pwsecret.” As previously noted, the “server secret” password entered here must match that
already configured as the Read‐Write (rw) password on the RADIUS server
:
D2(su)->set radius server 1 192.168.6.203 1812 pwsecret
This example shows how to set the RADIUS timeout to 5 seconds:
D2(su)->set radius timeout 5
This example shows how to set RADIUS retries to 10:
D2(su)->set radius retries 10
This example shows how to force any management‐access to the switch (Telnet, web, SSH) to
authenticate through a RADIUS server. The all parameter at the end of the command means that
any of the defined RADIUS servers can be used for this Authentication.
D2(rw)->set radius realm management-access all
clear radius
Use this command to clear RADIUS server settings.
Syntax
clear radius [retries] | [timeout] | [server {index | all | realm {index | all}}]
Parameters
Mode
Switch command, read‐write.
Defaults
None.
Note: If RADIUS is configured with no host IP address on the device, it will use the loopback
interface 0 IP address (if it has been configured) as its source for the NAS-IP attribute. For
information about configuring loopback interfaces, refer to “
interface ” on page 15-3.
retries Resets the maximum number of attempts a user can contact the RADIUS
server before timing out to 3.
timeout Resets the maximum amount of time to establish contact with the RADIUS
server before timing out to 20 seconds.
server Deletes server settings.
index | all For use with the server parameter to clear the server configuration for all
servers or a specific RADIUS server as defined by an index.
realm Resets the realm setting for all servers or a specific RADIUS server as
defined by an index.