Resetting the switch, Purpose, Commands – Enterasys Networks Enterasys D2 D2G124-12P User Manual
Page 88: Reset, Resetting the switch -50, Purpose -50 commands -50, Reset -50
Resetting the Switch
2-50 Basic Configuration
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Usage
By default, switch timeout occurs after 15 minutes of user inactivity, automatically closing your
CLI session. Use the
command (
) to change this default.
Example
This example shows how to exit a CLI session:
D2(su)->exit
Resetting the Switch
Purpose
To reset one or more switches, and to clear the user‐defined configuration parameters.
Commands
reset
Use this command to reset the switch without losing any user‐defined configuration settings.
Syntax
reset
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
For information about...
Refer to page...
reset
clear config
This manual is related to the following products: