Show ip address, Set ip address, Show ip address -9 set ip address -9 – Enterasys Networks Enterasys D2 D2G124-12P User Manual
Page 47: Ip address
show ip address
D-Series CLI Reference 2-9
show ip address
Use this command to display the system IP address and subnet mask.
Syntax
show ip address
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the system IP address and subnet mask:
D2(su)->show ip address
Name Address Mask
---------------- ---------------- ----------------
host 10.42.13.20
255.255.0.0
set ip address
Use this command to set the system IP address, subnet mask and default gateway.
Syntax
set ip address ip-address [mask ip-mask] [gateway ip-gateway]
set system name
set system location
set system contact
set width
set length
show logout
set logout
show console
set console baud
For information about...
Refer to page...
Note: The D2 does not support the ability for a user to configure the host's gateway to be a local
routed interface IP. The host's gateway must exist on a different device in the network if one is
configured.