Set length, Show logout, Set length -25 show logout -25 – Enterasys Networks Enterasys D2 D2G124-12P User Manual
Page 63
set length
D-Series CLI Reference 2-25
Example
This example shows how to set the terminal columns to 50:
D2(su)->set width 50
set length
Use this command to set the number of lines the CLI will display. This command is persistent
(written to NV‐RAM).
Syntax
set length screenlength
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the terminal length to 50:
D2(su)->set length 50
show logout
Use this command to display the time (in seconds) an idle console or Telnet CLI session will
remain connected before timing out.
Syntax
show logout
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
screenlength
Sets the number of lines in the CLI display. Valid values are 0, which
disables the scrolling screen feature described in “
” on page 1‐8, and from 5 to 512.