Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 240)

show spantree lptrapenable
6-48 Spanning Tree Configuration
show spantree lptrapenable
Use this command to display the current status of Loop Protect event notification.
Syntax
show spantree lptrapenable
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the current Loop Protect event notification status:
D2(rw)->show spantree lptrapenable
The Loop Protect event notification status is enable
clear spantree lptrapenable
Use this command to return the Loop Protect event notification state to its default state of
disabled.
Syntax
clear spantree lptrapenable
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the Loop Protect event notification state to the default of
disabled.
D2(rw)->clear spantree lptrapenable
set spantree disputedbpduthreshold
Use this command to set the disputed BPDU threshold, which is the number of disputed BPDUs
that must be received on a given port/SID until a disputed BPDU trap is sent.