Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 486)

set pwa ipaddress
15-62 Security Configuration
set pwa ipaddress
Use this command to set the PWA IP address. This is the IP address of the end station from which
PWA will prevent network access until the user is authenticated.
Syntax
set pwa ipaddress ip-address
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set a PWA IP address of 1.2.3.4:
D2(su)->set pwa ipaddress 1.2.3.4
set pwa protocol
Use this command to set the port web authentication protocol.
Syntax
set pwa protocol {chap | pap}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set a the PWA protocol to CHAP:
D2(su)->set pwa protocol chap
ip‐address Specifies a globally unique IP address. This same value must be
configured into every authenticating switch in the domain.
chap | pap Sets the PWA protocol to:
• CHAP (PPP Challenge Handshake Protocol) ‐ encrypts the username
and password between the end‐station and the switch port.
• PAP (Password Authentication Protocol‐ does not provide any
encryption between the end‐station the switch port.