Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 90)

show webview
2-52 Basic Configuration
Commands
show webview
Use this command to display WebView status.
Syntax
show webview
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display WebView status:
D2(rw)->show webview
WebView is Enabled.
set webview
Use this command to enable or disable WebView on the switch.
Syntax
set webview {enable | disable}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
For information about... Refer to page...
show webview 2-52
set webview 2-52
show ssl 2-53
set ssl 2-53
enable | disable Enable or disable WebView on the switch.