Commands, Show snmp user, Commands -8 – Enterasys Networks Enterasys D2 D2G124-12P User Manual
Page 162: Show snmp user -8
show snmp user
5-8 SNMP Configuration
Commands
show snmp user
Use this command to display information about SNMP users. These are people registered to
access SNMP management.
Syntax
show snmp user [list] | [user] | [remote remote] [volatile | nonvolatile | read-
only]
Parameters
Defaults
If list is not specified, detailed SNMP information will be displayed.
If user is not specified, information about all SNMP users will be displayed.
If remote is not specified, user information about the local SNMP engine will be displayed.
If not specified, user information for all storage types will be displayed.
Mode
Switch command, read‐only.
For information about...
Refer to page...
show snmp user
set snmp user
clear snmp user
show snmp group
set snmp group
clear snmp group
show snmp community
set snmp community
clear snmp community
list
(Optional) Displays a list of registered SNMP user names.
user
(Optional) Displays information about a specific user.
remote remote
(Optional) Displays information about users on a specific remote SNMP
engine.
volatile | nonvolatile
| read‐only
(Optional) Displays user information for a specified storage type.