Packet capture commands, Purpose, Commands – Enterasys Networks Enterasys D2 D2G124-12P User Manual
Page 392: Show rmon capture, Packet capture commands -20, Purpose -20 commands -20, Show rmon capture -20
Packet Capture Commands
13-20 RMON Configuration
Packet Capture Commands
Note that packet capture filter is sampling only and does not guarantee receipt of back‐to‐back
packets.
Purpose
To display RMON capture entries, configure, enable, or disable capture entries, and clear capture
entries.
Commands
show rmon capture
Use this command to display RMON capture entries and associated buffer control entries.
Syntax
show rmon capture [index [nodata]]
Parameters
Defaults
If no options are specified, all buffer control entries and associated captured packets will be
displayed.
Mode
Switch command, read‐only.
For information about...
Refer to page...
show rmon capture
set rmon capture
clear rmon capture
index
(Optional) Displays the specified buffer control entry and all captured
packets associated with that entry.
nodata
(Optional) Displays only the buffer control entry specified by index.