Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 223)

clear spantree legacypathcost
D-Series CLI Reference 6-31
Defaults
None.
Mode
Switch command, read‐write.
Usage
By default, legacy path cost is disabled. Enabling the device to calculate legacy path costs affects
the range of valid values that can be entered in the set spantree adminpathcost command.
Example
This example shows how to set the default path cost values to 802.1D.
D2(rw)->set spantree legacypathcost enable
clear spantree legacypathcost
Use this command to set the Spanning Tree default value for legacy path cost to 802.1t values.
Syntax
clear spantree legacypathcost
Defaults
None.
Mode
Switch command, read‐write.
Example
This example clears the legacy path cost to 802.1t values.
D2(rw)->clear spantree legacypathcost
Configuring Spanning Tree Port Parameters
Purpose
To display and set Spanning Tree port parameters.
Commands
For information about... Refer to page...
set spantree portadmin 6-32
clear spantree portadmin 6-32
show spantree portadmin 6-33