Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 397)

Configuring General DHCP Server Parameters
D-Series CLI Reference 14-3
Configuring General DHCP Server Parameters
Purpose
To configure DHCP server parameters, and to display and clear address binding information,
server statistics, and conflict information.
Commands
set dhcp
Use this command to enable or disable the DHCP server functionality on the D‐Series.
Syntax
set dhcp {enable | disable}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
For information about... Refer to page...
set dhcp 14-3
set dhcp bootp 14-4
set dhcp conflict logging 14-4
show dhcp conflict 14-5
clear dhcp conflict 14-5
set dhcp exclude 14-6
clear dhcp exclude 14-6
set dhcp ping 14-7
clear dhcp ping 14-7
show dhcp binding 14-8
clear dhcp binding 14-8
show dhcp server statistics 14-9
clear dhcp server statistics 14-10
enable | disable Enables or disables DHCP server functionality. By default, DHCP server
is disabled.